Join our mailing list!

  Home > Fuel and Tuning >

  95lb High Impedence Injectors
 
 
List Price: $525.00
Our Price: $450.00
You save $75.00!


Product Code: 95LB INJECTORS

Add to Wishlist
Description
 
Bosch's newest generation injectors are now available in a 1000cc saturated injector!!
All of our injectors are sold in matched sets of 4.  The sets are matched not only by flow, but by injector dead time.
Very very few people are offering this kind of matching consistency.  By matching the injectors based on both
dead time and flow, you end up with a set of injectors that are matched to 1% from minimum to maximum pulsewidth.
If you don't match the injectors based on dead time, you can easily end up with a 4-10% flow variance from i
njector to injector in the 2-3 ms range, where most of the life of the injector is spent.  
This can have a huge affect on idle quality and how smooth the engine runs.
 
Features
  • * High Impedance, no need for injector drivers or injector resistors
  • * High pressure capability, All injectors will run comfortably at 100psi above 10v, flow will be increased by approximately 50% at 100psi
  • * High duty cycle, with a recovery time of only 1ms, all injectors will run up to 92.5% duty cycle at 9k rpm and 95% duty cycle at 6k rpm while maintaining linearity within 1%
  • * Excellent low pulsewidth response, linearity within 2% all the way down to 2ms, predictable response down to 1.5ms. Using a 3 dimensional battery comp table with Motec V3 software, low pulsewidth response can be linearized to practically zero flow.
  • * Good atomization, Droplet size of the 1000cc injector is comparable to the Siemens Mototron 60lb injector, and is far better than the Multec 95lb, Standard Motor Products (RC) 1000cc and Siemens 72 and 83lb injectors.
  • * Excellent consistency, no sets will require more than a 1% trim
  • * Ruler flat response, unmatched linearity means easy tuning and accurate compensations.
  • Note - Fuel rail will need to be spaced out 10mm +/-. New injector connectors are included and will require cutting and crimping new terminals onto your wiring harness.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Fuel and Tuning


JR Electric Cylinder $70.00
Lowering Links, Fully Adjustable $124.95
DB-Blue Gauge / LC-1 Kit $229.00
Adams Performance Nitrous Solenoid $90.00
4 Channel Twin Fire Ignition Module $313.50
Air Shifter Kit $200.00
Busa Alum Sub $595.00
2 Inch Billet ZX-14 Oil Pan $850.00
Air Inlet Temperature (AIT) Sensor Kit Sensor $54.00